Keeping Machinery running all over the World
Menu
Home » Produkte » Öl-Schmierung » Positive Displacement Injector (PDI) System for Large Machines » AMO II - 150S

Positive Displacement Injector(PDI) System for Large Machines

Automatic intermittent gear pump AMO-II-150S

Specifications

Pump Discharge volume 150ml/ min (50Hz), 180ml/ min (60Hz)
Discharge pressure 2.0Mpa(15kgf/cm2) 284psi
Mortor Voltage / current AC100V?1/0.83A, AC200V?1/0.41A (50Hz)
AC100V?1/0.64A, AC200V?1/0.33A (60Hz)
Output 20W (50Hz/ 60Hz) Condenser Mortor
Emergency detection Oil level pressure
Oil level switch
Contact type A Contact (NO) ON at low level
Contact capacity 0.5A AC DC200V/30W smaller
Prerssure switch
Contact type A Contact (NC)
Operating pressure: 1.7MPa OFF
Reset pressure: 0.9MPa ON
Contact capacity AC DC250V/3A
Discharge time Max. Discharge time:99sec
Min. Interval time:1min
Working viscosity range 68?1000mm2/S (50Hz)
Reservoir capacity 1.8l,3l (plastic) 3l,4l,8l (sheet metal)
Weight 1.8l Reservoirs: 3.2kg 3l Reservoirs: 4kg(plastic)

How To Order

How To Order

Model

Model Part Number
AMO-II-150S-1 202067
AMO-II-150S-1-3 202069
AMO-II-150S-1-P 202071
AMO-II-150S-1-P-3 202073
Model Part Number
AMO-II-150S-2 202068
AMO-II-150S-2-3 202070
AMO-II-150S-2-P 202072
AMO-II-150S-2-P-3 202074

Directions for use

  • This pump unit requires a separate control circuit to operate.
  • Do not remove the oil strainer to keep the pump clear of foreign matter.
  • Replace or clean the suction filter at least once a year. Click here to view the service list.
  • Oil viscosity varies with oil temperature. Be sure to use oil within the working viscosity range. Refer to the viscosity table.
  • Oil viscosity varies with oil temperature. Be sure to use oil within specified working viscosity range. Click here to view the viscosity list.
  • Do not use any special additive-contained oil, water soluble oil and solvent.
  • Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately. Be sure to clean the reservoir before oil change.
  • Make sure that proper voltage and pressure are proper.
  • Do not overtighten the discharge joint.
  • Refer to the tightening torque table.
  • Low-oil viscosity versions are available. Contact us for information.
  • For system planning information, click here.
  • * Should the pump malfunction, Contact us for immediate response with substitution.

Drawing

Hydraulic circuit drawing

Hydraulic circuit drawing

Wiring digram

Wiring digram

Dimensional drawing

Dimensional drawing