Keeping Machinery running all over the World
Menu
Home » Produkte » Öl-Schmierung » (SLR) Single Line Resistance compact system for small machines to large machines with continuous (rec) » AMS

Automatic small discharge volume gear pump

AMS

Motor driven gear pump for continuous micro-volume lubrication used with a resistance type centralized lubrication equipment.

AMS

Specifications

AMS-1 AMS-3 AMS-6
Pump Discharge volume AMS-1:1.25ml/min (50Hz)?1.5ml/min (60Hz)
AMS-3:2.5ml/min (50Hz)?3ml/min (60Hz)
AMS-6:5ml/min (50Hz)?6ml/min (60Hz)
Discharge pressure 0.8MPa (safety valve setting)

Motor
(Other voltages available.)

Power AC100V?1/50mA?AC200V?1/25mA (50Hz)
AC100V?1/42mA?AC200V?1/18mA (60Hz)
AC100V?1/25mA?AC200V?1/18mA (60Hz)
Output 3W Synclonous Motor
Emergency detection Oil level switch Contact type A contact (NO) ON at low level
Contact capacity 0.5A,
AC DC200V/30W smaller
Operation rate Continuous
Working viscosity range 32-1300mm2/S
Reservoir capacity 0.8L, 3L (plastic) 3L, 4L, 8L (sheet metal)
Weight 1.8kg
AMS-15
Pump Discharge volume 15ml/min (50Hz)?18ml/min (60Hz)
Discharge pressure 0.8MPa (safety valve setting)
Motor
(Other voltages available.)
Power AC100V?1/0.25A (50/60Hz) 200V?1
Output 5.0W Accessory - Condesor 3,.0 F
Gear Head Speed Reduction Ratio: 1/25
Working viscosity range 32-1300mm2/S
Reservoir capacity 0.8L, 3L (plastic) 3L, 4L, 8L (sheet metal)
Weight 2.3kg

HOW to order

HOW to order

Replacement Motor Model

pump Part Number

Voltage

Replacement Motor Model
AMS-1 521194 100V M-B1
521196 200V M-B2
AMS-3 521194 100V M-B1
521196 200V M-B2
AMS-6 521210 100V M-A1
521328 200V M-A2

Directions for use

  • Oil viscosity varies with oil temperature. Be sure to use oil within the working viscosity range. Refer to the viscosity table.
  • Do not use any special additive-contained oil, water soluble oil and solvent.
  • Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately. Be sure to clean the reservoir before oil change.
  • Make sure that proper voltage is applied.
  • Do not over tighten the discharge joint. Refer to the tightening torque table.

drawing

Hydraulic circuit drawing

Hydraulic circuit drawing

 

Wiring diagram

Wiring diagram

Dimensional drawing

Dimensional drawing